17kg Tub: Bostik - H200 Elastic - Wood Flooring Adhesive - High Performance Single Component Hybrid Adhesive

SKU: BOS-H200EL-17KG
17kg Tub: Bostik - H200 Elastic - Wood Flooring Adhesive - High Performance Single Component Hybrid Adhesive Bostik WOOD H200 ELASTIC is a high performance, permanently elastic, single component hybrid adhesive for surface bonding all types of parquet flooring on absorbent and non-absorbent surfaces. Available in a 17kg bucket, the adhesive has high mechanical and acoustic properties which can reduce the impact of sound by up to 18dB (with an undercoat). Bostik WOOD H200 ELASTIC can be used with all types of wood flooring including unfinished or varnished solid wood floors up to 200mm wide, bonded floors of all sizes, edge-grain wood, end-grain wood and all wood species including beech and exotic woods. It's also suitable for use with warm water underfloor heating systems where the floor surface temperature does not exceed +27C.
£129.93
Uses Bostik WOOD H200 ELASTIC is a high performance, permanently elastic single component hybrid adhesive for surface bonding all types of parquet flooring on absorbent and non-absorbent surfaces. It has high mechanical and acoustic properties. It can be used for bonding all types of wood flooring including: unfinished or varnished solid wood floors up to 200mm wide, bonded floors of all sizes, edge-grain wood, end-grain wood and all wood species, including beech and exotic woods. It is suitable for use with warm water underfloor heating systems, provided a surface temperature of +27C is not exceeded. Product characteristics Colour: Light brown Form: Medium viscosity paste Specific gravity: 1.4 - 1.6 approx. Composition: Hybrid polymer-based Product codes: 30615783 17kg bucket Storage / shelf life: Store and transport securely in an upright position. Ensure the lid is secure. Store for up to 12 months from date of manufacture in original, unopened packaging in cool, dry conditions within the temperature range +10C to +30C and out of direct sunlight . Protect from frost Typical performance data Application temperature: +10C to +30C Coverage: Up to 23m per 17kg (depending on the trowel used, smoothness of the floor surface & application technique) Open times: 30 minutes (depending on drying conditions) Drying times: Foot traffic approx. 24 hours / Sanding and varnishing approx. 48 hours (depending on drying conditions) VOC emissions: Very low emissions EC1 Plus Cleaning: Clean tools and equipment with white spirit immediately after use. Do not allow to cure, remove excess adhesive immediately by scraping off, then cleaning with a cloth dampened with white spirit. Cured adhesive can only be removed mechanically Directions for use IMPORTANT: Before using Bostik WOOD H200 ELASTIC, refer to the relevant Health & Safety Data Sheet, available at the top of this page under "Documents" All phases of installation must comply with the latest editions of the following standards: BS 8102 Code of Practice for protection of building against water from the ground.
You May Also Like