Uses Bostik WOOD H180 CLASSIC-P is a high performance, permanently elastic, single component hybrid adhesive for surface bonding most types of wood.
With rapid fixing, strong ultimate cohesion and low VOC emissions (EC1), Bostik WOOD H180 CLASSIC-P can be used with wood block, wood mosaic panels, strip parquet, engineered wood flooring and solid wood floors up to 180mm wide.
The adhesive is not suitable for use with solid beech.
Available in a 14kg bucket, the adhesive can be bonded onto concrete, wood, metal decking, ceramic tiles and anhydrite screed. It is also suitable for use with warm water underfloor heating systems where the floor surface temperature does not exceed +27C.
Product characteristics:
| Colour: | Beige |
| Form: | Medium viscosity paste |
| Specific gravity: | 1.4 - 1.6 approx |
| Composition: | Hybrid polymer-based |
| Product codes: | 30616178 14kg (2x 7kg pouches) 30616266 17kg bucket |
| Storage / Shelf life: | Storage and transport securely in an upright position. Ensure the lid is secure. Store for us to 12 months from date of manufacture in original, unopened packaging in cool, dry conditions within the temperature range +10C to +30C and out of direct sunlight. Protect from frost. |
Typical performance data
| Application temperature: | +10C to +30C |
| Coverage: | 1kg - 1.4kg/m (depending on the trowel uses, smoothness of the floor surface & application technique) |
| Open times: | 40 minutes (depending on the drying conditions) |
| Drying times: | Foot traffic approx. 24 hours / Sanding and varnishing approx. 48 hours (depending on drying conditions) |
| VOC emissions: | Very low emissions EC1 |
| Cleaning: | Clean tools and equipment with white spirit immediately after use. Do not allow to cure, remove excess adhesive immediately by scraping off, then cleaning with white spirit. Cured adhesive can only be removed mechanically. |
IMPORTANT: Before using Bostik WOOD H180 CLASSIC-P, refer to the relevant Health & Safety Data Sheet, available under the "Documents" tab All phases of installation must comply with the latest editions of the following standards: BS 8102 Code of Practice for protection of building against water from the ground
